Wheels
Page 1 of 4 (36 Questions and Answers)

 MLA Citation: Bloomfield, Louis A. "Wheels" How Everything Works 22 Jul 2018. Page 1 of 4. 22 Jul 2018 .
62. I didn't understand how a car (or wagon) starts its motion.
A wagon starts its motion when you pull it or push it. If its wheels weren't touching the ground, they would simply move along with the wagon and would not turn. However, they are touching the ground and the ground exerts a backward frictional force on them to keep them from sliding on the ground. This backward frictional force causes the wheels to begin turning.

A car starts its motion when the engine of the car exerts a torque on its wheels. These wheels begin to rotate. However, the wheels are again touching the ground and the ground exerts a frictional force on the wheels to keep them from skidding. This frictional force not only opposes the wheels' angular acceleration, it also causes the wheels and the car to which those wheels are attached to accelerate horizontally.

63. In the book, you discussed pushing on a file cabinet that was resting on the sidewalk. Why doesn't the file cabinet move when you push even a little — you're making the net force greater than zero?
When you exert a small horizontal force on the file cabinet, it doesn't move because static friction between the ground and the file cabinet exerts a second horizontal force on the file cabinet that exactly balances your force. If you push the file cabinet west, the ground will exert a static frictional force on the file cabinet, pushing it east. The file cabinet will thus experience a net force of zero. You'll have to push very, very hard before static friction will be unable to match your force. One you do exceed the limit of static friction, the friction will no longer be able to balance your force and the file cabinet will experience a net force in the horizontal direction. The file cabinet will then accelerate in the direction of your force.

64. Is a spinning toy top a perfect example of angular momentum?
Yes. If you spinning it about a vertical axis (so that gravity doesn't exert a torque on it about its point), it will spin at a steady angular velocity almost indefinitely. Sliding friction does slow it gradually but if the point is very sharp, sliding friction there exerts very little torque on the top about its rotational axis. Because it's unable to exert a torque on the ground, the top can't exchange angular momentum with the earth. It spins on until it slowly gets rid of its angular momentum through sliding friction and air resistance.

65. What exactly is the different between momentum and inertia?
Inertia is a concept—the property of an object to resist any change in its velocity. Momentum is a vector quantity—the product of an object's mass times its velocity and an important characteristic of a moving object. Momentum is important because it's conserved and it's conserved in large part because of inertia and related concepts.

66. What's going on with the wheels when a car accelerates?
As a car heads forward, its freely turning wheels begin to rotate. The torque that starts them rotating comes from static friction with the ground. The ground pushes backward on the bottoms of the wheels to keep them from sliding and this backward frictional force exerts a torque on the wheels. They begin to rotate so that their bottom surfaces head backward and their top surfaces head forward.

The car's powered wheels turn for a different reason: they are driven by a torque from the car's engine. As you step on the accelerator, the engine exerts a torque on the wheels and they begin to turn. They would skid backward across the ground where it not for static friction between the wheels and the ground. This static friction opposes the skidding by exerting a forward force on the bottom surface of the wheels. This static frictional force produces a torque on the wheels and that torque partly balances the torque from the engine. The wheels don't skid and they're angular velocities increase relatively slowly. However, the forward frictional force on the wheel's bottom surface isn't balanced elsewhere in the car and the car experiences a forward net force. The car accelerates forward.

67. Where does energy go when you try to push a heavy object and it doesn't move? Thermal energy isn't made, so why do people get tired?
While it's true that there is no thermal energy made by static friction, since the object doesn't slide, your body can still make thermal energy directly. You get tired because your muscles must turn useful food energy into thermal energy whenever they are under tension. If you are doing work, they also convert food energy into that work, but even when they aren't doing work, they still convert food energy into thermal energy.

68. Why are tires filled with air instead of something less likely to go flat?
This is an interesting question with several answers. First, a solid rubber tire would have a huge mass and would require consider work to accelerate. Because it rotates as the car moves, a tire stores twice as much kinetic energy as the other parts of the cars. By reducing the mass of the tires, the car reduces the amount of energy it must put into the tires to get them moving and the amount of energy it must remove from the tires to stop them from turning.

Secondly, a solid rubber tire would be so hard that it would give the car a very rough ride. The air in the tires cushions the car against many of the rough spots it drives over. Without the air cushion, the wheels and axles would bound up and down with every pebble in the road.

Lastly, a solid rubber tire would be very expensive. The materials used in a tire are expensive and a tire's cost should be roughly proportional to its weight. Since a solid tire would weigh much more than an air-filled one, it would also cost much more. Its tread would still wear out, so it wouldn't last any longer than an air-filled tire.

69. Why is it that we can use energy without doing work? Where does this energy go? For example, you could push on a wall until your arms fell off, but you wouldn't have done any work.
When you are pushing on something without doing any work, your energy is being converted directly into thermal energy inside your body. Your muscles are inefficient and they convert food energy into thermal energy whenever they are under tension. It's like a car, which uses gasoline even when it's stopped at the light. The engine keeps running but it does no work. Similarly, if you simply burned your cereal in your breakfast bowl, you would turn its energy directly into thermal energy without doing any useful work. Your body is also able to burn up that food energy and create thermal energy, albeit a little less visibly.

70. Why is the frictional force on a wagon's wheel in the opposite direction from the frictional force on a car's wheel?
When you pull a wagon forward, friction from the ground starts the wheel turning and it does this by pushing backward on the bottom of the wheel. Friction is thus preventing the wheel from skidding across the pavement. When you step on a car's accelerator, the car's engine starts the wheel turning and friction from the ground pushes forward on the bottom of the wheel to prevent the wheel from skidding across the pavement. In the first case, friction is trying to help the wheel to turn while in the second case friction is trying to keep the wheel from turning. That's why the forces (and the resulting torques) on the wheel are in opposite directions for the two cases.

557. What are some everyday examples of friction? (For example, we couldn't walk without friction.)
Before giving some examples, I'll note that there are two different types of friction. First, there's the static friction between two surfaces that are pressed together but are not sliding across one another. Second, there's the sliding or dynamic friction between two surfaces that are moving across one another. Static friction allows objects to push one another sideways but doesn't create thermal energy. Sliding friction also creates thermal energy (or heat).

Your example of walking is a case of static friction: your feet push backward on the sidewalk and the sidewalk reacts by pushing your feet (and you) forward. As further examples of static friction: holding a pencil, screwing in a light bulb, pulling a rope toward you hand over hand, pedaling a bicycle so that the ground pushes the wheel forward, keeping the dishes and silverware from blowing off a level picnic table on a windy day...

As examples of sliding friction: skidding the wheels of a automobile during a rapid start or stop, sliding down the pole in a fire station, skiing or skating, squeezing a bicycle's caliper brakes against the wheel rims, shaping metal with a grinding wheel, sharpening a knife, sanding a wooden desktop...

www.HowEverythingWorks.org