|MLA Citation:||Bloomfield, Louis A. "Question 1061"|
How Everything Works 19 Jan 2018. 19 Jan 2018 <http://howeverythingworks.org/print1.php?QNum=1061>.
In a three-way touch lamp, the lamp's electronics control 4 different light levels alternately: dim, medium, bright, and off. How these light levels are obtained depends on the lamp. If the lamp uses a three-way light bulb, which contains two separate filaments, then it can obtain the 3 brightness levels by turning on one or both of the filaments. It uses just the small filament for dim, just the large filament for medium, and both filaments for bright. That's exactly what a normal three-way lamp does.
But if the lamp uses a normal bulb and obtains three light levels from it, then it uses the same technique as a dimmer switch. In this technique, an electronic switching device called a triac is used to limit the times during which electric current can flow through the bulb and deliver power to it. In the bright setting, the triac permits current to flow through the bulb at all times and the bulb appears as bright as possible. But in the dim or medium settings, the triac prevents current from flowing at certain times. The triac takes advantage of the fact that the power flowing through a household lamp is alternating current—current that reverses directions 120 times a second (in the United States) for a total of 60 full cycles of reversal, over and back, each second (60 Hz). At the beginning of each current reversal, the electronic devices that control the triac start a timer. This timer allows those devices to wait a certain amount of time before they trigger the triac and allow it to begin carrying current to the light bulb. Once triggered, the triac will allow current to flow through the bulb until the next reversal of current in the power line. Thus the amount of energy that reaches the bulb during each half-cycle of the power line depends on how long the electronic devices wait before triggering the triac. The longer they wait, the less energy will reach the bulb and the dimmer it will glow. In the bright setting, the triac is triggered immediately after each current reversal so that power always flows to the bulb and it glows brightly. But in the medium and dim settings, the triac is triggered well into the half-cycle that follows the reversal. A normal dimmer gives you complete control over this delay, but a three-way touch switch only provides three preset delays. The medium setting has a medium delay while the dim setting has a long delay.